Hi there,
We have four systems that currently have EWA created for them.
I applied a patch ST-PI, ST-A/PI a few weeks back on BWP.
Its a bit of a coincideance that I am now not receiving the EWA by email
like I used to.
When I go into DSWP on our solition manager system (SMD), I can see
the following:
I dont know too much about the EWA. I can see that for the systems PR1, EPP and SMD
the report was produced and I did receive it in an email for each of them.
For BWP however, I didnt receieve the EWA via email.
When I run RTCCTOOL - Service Preparation check on BWP all looks good:
Can anyone tell me where to look? Or what I am doing wrong?
Thanks
Andy